More noob questions.
Since it looks like I will go the bridged route with passive crossovers, do I still use the HPF and LPF on the amp for anything, just SUB?
In the below pic, I think the top row is for the Sub, bottom row for front/rear.
For front, is this right:
- Set channel mode = Bridged
- Level = all the way down until ready to tune?
- HPF?
- LPF?
- Set for "Full" or "HPF"?
Sub woofer, top row:
- Source = Ext.
- Level = low to start?
- Subsoninc = ? Woofer has a range from 20 - 250 Hz, so put it lowest? Sub has a slot-ported enclosure if that matters.
- Set to LPF?
- LPF = 80 Hz?
Rear is not used in bridged mode right? I also don't need to run rear pre-amp cables from HU to amp?
I changed the front components to the RF T2652-S. RMS/Peak 100/200
https://www.sonicelectronix.com/item...r-T2652-S.html
When amp is bridged at 4 Ohms, RMS power is 230 W x 2 + 440 W X 1