01-22-2021, 05:58 PM
|
#10
|
|
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,936
|
Re: Auto Tilt Lower Column Bearing
Quote:
Originally Posted by SCOTI
Well, The kit I purchased from Crown said from late 60's on up through the 90's but the bearing is a 1" ID. When I tried to find the .750" ID size is where I found many (most) marketed stuff wants to know what vehicle you're working with & tells you yes/no if it will work.
Since there are different shaft diameters, it would be better to confirm the bearing ID vs. an online source saying "it will fit".
|
Agree, I looked at several sites. 3/4" ID = 19mm which is a tad under 3/4".
OD 1" = 25.4mm. I think if you could find one it would work but finding it is seeming to be the problem. All the 3/4" ID bearings I found had a 1-3/8" OD.
I chatted with Lily bearing tech support. He said he would be back in touch with me Monday on a answer to this bearing.
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver
Seeing the USA in a 71 
Upstate SC GM Truck Club
2013,14 and 2016 Hot Rod Pour Tour
http://upstategmtrucks.com/
Get out and drive the truck this summer and have some fun!
It sucks not being able to hear!
LWB trucks rule, if you don't think so measure your SWB!
After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs.
Last edited by Andy4639; 01-22-2021 at 06:13 PM.
|
|
|