The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

brossow · 10-15-2007, 12:11 PM

Work came to a standstill because of the pinion bearing issue, which I finally got resolved on October 3. But now I'm stuck again for lack of proper tools to get the posi installed! If it's not one thing it's another, as I'm sure you all know.

Finally got the engine pulled and sold about three weekends ago. Picked up a 700R4 and various sheetmetal the weekend before last, including a pair of doors, five rust-free fenders, a rust-free hood, and various other pieces from a gentleman who was getting out of the hobby and wanted to make sure I had some parts to use and/or trade. Nice guy! No accomplishments at all since then.

10-15-2007, 12:11 PM	#10
brossow Amateur Rust Fighter Join Date: Sep 2007 Location: Mankato, MN Posts: 1,087	Re: Brent's '72 Custom/10 SWB stepside build Work came to a standstill because of the pinion bearing issue, which I finally got resolved on October 3. But now I'm stuck again for lack of proper tools to get the posi installed! If it's not one thing it's another, as I'm sure you all know. Finally got the engine pulled and sold about three weekends ago. Picked up a 700R4 and various sheetmetal the weekend before last, including a pair of doors, five rust-free fenders, a rust-free hood, and various other pieces from a gentleman who was getting out of the hobby and wanted to make sure I had some parts to use and/or trade. Nice guy! No accomplishments at all since then. Attached Images __________________ Brent '72 Chevy SWB stepside - [ Build Thread ] '79 ChevMC SWB fleetside - [ Build Thread ] '64 Chevy SWB fleetside & '66 Chevy SWB stepside (waiting in the wings...) Last edited by brossow; 10-15-2007 at 12:22 PM.