View Single Post
Old 07-03-2018, 08:44 PM   #53
ncpetersc
Registered User
 
ncpetersc's Avatar
 
Join Date: Jun 2018
Location: Fuquay-Varina, NC (Just outside of Raleigh)
Posts: 237
Re: Help a NOOB - A continuing saga

Quote:
Originally Posted by AussieinNC View Post
Re...white smoke, especially from drivers side...this is an auto truck...the trans uses a vacuum modulator that senses engine vacuum to determine shift quality...the vacuum line from the trans fits into a small rubber line that plugs into the rear of the manifold .....if the vacuum modulator splits and they do regularly...the engine vacuum will suck transmission fluid up into the manifold and with the result lots of white smoke....and I mean lots...

Remove the vacuum hose to the trans and plug the manifold port...then run the engine again...it will take some time to burn out the trans oil in the manifold if this has been leaking...

If it leaking, they are relatively easy to replace...but we will cross that bridge later.

I read about this about a year ago when I was chasing down the cause of the white smoke. I replaced the modulator back then, but it didn't seem to be the solution. It's actually not smoking as bad now as it did, so I was wondering if the bent push rods explained it with valves not opening as they should.
ncpetersc is offline   Reply With Quote