[DURG]

I have pretty much wrapped up the rear suspension now. Not shown, but I now have the frame side panhard bar mount tacked in so I can check it at my final ride height. I have installed a weld in plate on the inside of the frame rails at the 4 link front mounts, and another one that bolts to it so I can install bracing from the center Porterbuilt crossmember similar to what Nate did on the coilover version he has posted on his site. It will all be removeable when done. I had to trim a bit of the upper coilover mounts to get the upper spring seat to clear, and modify my frame side panhard bar mount a little. The picture of the whole truck is really close to actual ride height which is just what I was looking for with this static drop suspension setup.