|
Re: Gen 3 Drive By Wire cruise control HOW TO
Ok, I just wired everything exactly the way this diagram is showing and when I check my relay with key on the small light on the left upper corner lights up "on" when I press the switch "on" I have NO power at 87a (brown wire from switch) when I press set/cruise (nothing) at 30 (relay #1) resume/accelerate (nothing) at 30 (relay#2)
Now per (Dakota Digital) the wiring they have the red wire from this switch is going to the "hot side" of brake switch (which is 12v always) so if I put this red wire to that connection the "on" light stays on all the time, I unplug it and it goes off. So this time I wired it as the diagram below shows and it lights up as soon as I turn the ignition switch on but as I have stated I have NO power as I should be getting.
I also included the DD wiring so its easier to see what I'm talking about.
Any insight would be greatly appreciated Thanks
Mark
|