The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Clarance J · 05-15-2017, 04:30 PM

Hello guys. This goes back to early 2008. At that time my welding skills were not that good but I needed to get the doors back on my truck to make it drivable. I figured out a way to make it a no-weld needed fix. I did tack weld nuts on the back side but those could be left off. Just as a side note my welding skills have improved since then.

Good job there Oldtruckwelder.

Earl

05-15-2017, 04:30 PM	#14
Clarance J Registered User Join Date: Feb 2013 Location: Grants Pass Oregon Posts: 473	Re: Captive nuts Hello guys. This goes back to early 2008. At that time my welding skills were not that good but I needed to get the doors back on my truck to make it drivable. I figured out a way to make it a no-weld needed fix. I did tack weld nuts on the back side but those could be left off. Just as a side note my welding skills have improved since then. Good job there Oldtruckwelder. Earl Attached Images __________________ You have to have patiences or you'll be one.