[Boog]

Not sure what you're wanting to know but I recently swapped the dull composite lamps on my 97 for the dual halogen sealed beams from an 88. It is a bolt in affair, no wire harness mods either. Just snap the grille out and 4 bolts remove the headlamp assembly. I did have to twist the prongs 1/4 turn on the low side lamps for the wiring plug to hook up but that's all. 30 minute job. I can see again!
I did this because: 1) I like the sealed beams betterj
2) glass lense will not dull
3) I did not want to have to sand and buff
the plastic housings once a yr to keep them up.
4) the aftermarket ones fall short and the OEM ones
are too expensive.
5) did I mention I like the sealed beams better?
See for yourself.