Quote:
Originally Posted by 4x4k30
I looked at my 6.0 that's sitting in the floor DO NOT GRIND THE SPOT WHERE THE STARTER BOLT GOES..the top spot you have marked it can be grinded some but I would for sure don't mess where the starter bolt goes. now my engine is different its a gen 3 but it should be the same the pic shown looks to a be gen4
|
Yeah the lower part has one of the starter bolts. Any grindin there will be minimal, just to take the corners off. I may have to dimple the header at that spot for clearance.
Thanks for the replies fellas!