Quote:
Originally Posted by cpnbnanamn
The rear turn signals and brakelights do work, and so do the front parking lights when the hazards are on. It seems that the issue is after the switch, and I am trying to figure out where.
|
It sounds to me like your hazard switch is bad. Your wiring circuits are good but you aren't getting power to them from the hazard switch. You must be getting power to the hazard switch if the fronts flash, but not the rears. And you must be getting power to the fronts through the switch because the fronts are flashing.
Unplug the half moon connector and do a continuity check between the brown wire in the connector and the dark green wire. Look for zero ohms and then do the brown, and yellow wires looking for zero ohms. This is on the wires that go to the turn signal switch.
Your wires in the harness might not be the same colors on both sides of the half moon connector, so you might have to match them up with the wires on the other side of the connector, that comes from the fuse panel. When you check the wires be sure to pull the hazard switch on. You can also check the two blue wires too, and they should have zero ohms since the fronts do work.,
Here's a picture. notice that all the wire colors don't match, but you wires should because your lights work. If you are confused then just post back and I'll clarify it more for you.