[65Robb]

Its in finally overdrive in my baby!! had to use a th350 crossmember fit like a glove only issues I ran into was the holes on the crossmember to the holes in the frame where 1/2" off of eachother. so to make sure I was square with the crossmember in the frame I got the four rear holes to line up two on the bottom an the two on the top. so I put the bolts in those holes and tightened them down now I drilled the crossmember for the bottom holes and drilled the frame for the top of the crossmember. the second issue I ran into was I had to remove the rivets and put the e brake crossmember 1 1/2" below the frame rails.