The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Steven R · 01-10-2017, 01:09 AM

So AFTER these two repair there are a few areas that I would like to fix that have pin holes in. I plan to use a few different pce of copper as a backer and weld up these holes and then metal finish. My question is do i just continue to use steel wire or should I go and get a different type of wire like silicon bronze wire. 90 percent of these holes are on the bottom of the door and a few at the inner toe kick area.

Looking for your thoughts.

01-10-2017, 01:09 AM	#4
Steven R Registered User Join Date: Jul 2015 Location: landmark, MB Can Posts: 288	Re: Rust repair Better then I thought... So AFTER these two repair there are a few areas that I would like to fix that have pin holes in. I plan to use a few different pce of copper as a backer and weld up these holes and then metal finish. My question is do i just continue to use steel wire or should I go and get a different type of wire like silicon bronze wire. 90 percent of these holes are on the bottom of the door and a few at the inner toe kick area. Looking for your thoughts.