View Single Post
Old 01-05-2012, 03:07 AM   #12
prostreetC-10
My Carbon Footprint
 
prostreetC-10's Avatar
 
Join Date: Oct 2008
Location: Orygun
Posts: 5,527
Re: Shaft bushings in Q-jet throttle plate

Quote:
Originally Posted by Captainfab View Post
When I rebuilt my Holley 3310-1 about 20 years ago, the kit I bought (Holley kit) came with the teflon strips for the throttle shaft bores. I haven't checked them in a while, but last I knew they were just fine after 120,000 miles or so.
Those strips come in the kit because certain Holley shafts have a recess on the shaft itself that the teflon strip goes into. If you have the more standard shaft, the strips will do you no good because there is no clearance for them. You would have to enlarge the bore in the base plate.
prostreetC-10 is offline   Reply With Quote