Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
11-03-2011, 07:18 PM | #1 |
Registered User
Join Date: Jan 2010
Location: GREENEVILLE TENNESSEE
Posts: 1,310
|
1999 4L60E trans rebuild with the PWM
It is in my 99 tahoe. 2wd 116,000 miles.i took it to a small shop to get a rebuild..and a new converter.and i drove it 10 miles same thing
I told him it had a shudder in the converter after it was hot and after a long run..when i got home..the trans sounding like marblem in the converter.. I am new to these 4l60e's and never rebuilt one before.. I am going to try it this time. Now on this new trans you have to remove the bellhousing to get the front pump out and back in without destroying the o-ring seal on the front pump. he said he never got the bell off and put clutches in it..from o-rielly's and i called there , they cant even get a rebuild kit.. he said the converter was redone..yea with a black primer can from wally world.. also he said wires were touching the pan,he soldered them and shrink wrapped them...yea right not when i took it apart. also had a new B&M shift kit..with spacer plate..just as i thought..not in there.. He took my money and my shift kit,put a primer paint job on the converter and a new trans filter kit and seals.thats all he did.. sorry about the rant ,but it just isnt right I got took for 350 bucks.. so i am doing it myself. anything i need to know about the inside on this thing..I have bits of torrington bearing from the converter all in the clutches. another thing is there a "dial" to change the torque lockup or overdrive in there? I dont beleve that he said too.. it shifted into overdrive at 40mph. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|