Question About Edelbrock Vacuum Ports & Charcoal Canister - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**pjmoreland** · 08-26-2005, 06:27 PM

I'm trying to figure out how to connect my vacuum canister to my Edelbrock carburetor. This thread outlines most of the connections:

http://67-72chevytrucks.com/vboard/s....php3?t=169702

I'm not sure where to connect the small line that comes from the center cap of the charcoal canister. I'm not sure, but I believe this line opens and closes a valve inside the canister.

I have my distributor vacuum advance connected to the port on the front of the carburetor labeled "1" in the picture. Should I connect the center cap of the charcoal canister to the other fitting (2)?

08-26-2005, 06:27 PM	#1
pjmoreland Senior Member Join Date: Jan 2005 Location: CA Posts: 5,349	Question About Edelbrock Vacuum Ports & Charcoal Canister I'm trying to figure out how to connect my vacuum canister to my Edelbrock carburetor. This thread outlines most of the connections: http://67-72chevytrucks.com/vboard/s....php3?t=169702 I'm not sure where to connect the small line that comes from the center cap of the charcoal canister. I'm not sure, but I believe this line opens and closes a valve inside the canister. I have my distributor vacuum advance connected to the port on the front of the carburetor labeled "1" in the picture. Should I connect the center cap of the charcoal canister to the other fitting (2)? Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.