It's good to be back again! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

JESSEGALLEGOS · 01-07-2007, 11:26 PM

I have had my truck for about 7+ years and basically used it as a forum of transportation and have not really taken care of it.

In fact I had planned on selling it last month and was getting a 1999 2WD full size Blazer and at the last minute came to my senses. Anyways I have a question. The Blazer has a 2" lift in the front and 3" in the rear and want to lower it. I have 2-1/2" spindles and 2" springs for the front and a flip kit for the rear. Is the rear going to sit to low? compaired to the front? Will I have to notch the rear of the frame?

Thanks and it's good to be back!

01-07-2007, 11:26 PM	#1
JESSEGALLEGOS Registered User Join Date: Jul 2001 Location: LAKE PLACID FLORIDA Posts: 95	It's good to be back again! I have had my truck for about 7+ years and basically used it as a forum of transportation and have not really taken care of it. In fact I had planned on selling it last month and was getting a 1999 2WD full size Blazer and at the last minute came to my senses. Anyways I have a question. The Blazer has a 2" lift in the front and 3" in the rear and want to lower it. I have 2-1/2" spindles and 2" springs for the front and a flip kit for the rear. Is the rear going to sit to low? compaired to the front? Will I have to notch the rear of the frame? Thanks and it's good to be back! __________________ 1982 BLAZER 2WD http://img.photobucket.com/albums/v7...t/145c37fd.jpg



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.