Springs and spring cups - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Kas68c10 · 05-17-2002, 05:42 PM

Putting new rear coil springs, cups and trailing arms in the truck. I know the ends of the springs are supposed to line up with the indents in the cups. That was fine in the top, but when I tighten down the lower the cup spins.The cups seem to fit the springs ok, but not if I line up the indents to the ends, it is off by small amount. Should I wait until the truck is on ground to tighten ? Is it possible that I have wrong srpings and or cups,or the cups/springs switched top to bottom ? Any input appreciated.
Thanks

------------------
1968 SWB Stepside, pwr disc brake and tilt pwr steering, 5 spd tranny, HEI,Accel coil,K&N filter,3 bolt seatbelts, original i6 and wood bed, seat from an 89 Chevy, front and rear sway bars, moved gas tank to under the bed, headman hedders, new chrome bumpers,one wire alternator,WORK IN PROGRESS,Daily driver, 20 MPG, Freeland MI

05-17-2002, 05:42 PM	#1
Kas68c10 Registered User Join Date: Apr 2000 Location: Freeland,Michigan,USA Posts: 312	Springs and spring cups Putting new rear coil springs, cups and trailing arms in the truck. I know the ends of the springs are supposed to line up with the indents in the cups. That was fine in the top, but when I tighten down the lower the cup spins.The cups seem to fit the springs ok, but not if I line up the indents to the ends, it is off by small amount. Should I wait until the truck is on ground to tighten ? Is it possible that I have wrong srpings and or cups,or the cups/springs switched top to bottom ? Any input appreciated. Thanks ------------------ 1968 SWB Stepside, pwr disc brake and tilt pwr steering, 5 spd tranny, HEI,Accel coil,K&N filter,3 bolt seatbelts, original i6 and wood bed, seat from an 89 Chevy, front and rear sway bars, moved gas tank to under the bed, headman hedders, new chrome bumpers,one wire alternator,WORK IN PROGRESS,Daily driver, 20 MPG, Freeland MI __________________ 1968 SWB Stepside, 250,pwr disc brake and tilt pwr steering, 5 spd tranny, HEI,Accel coil,K&N filter,Seat from a later truck with built in seatbelts, front and rear sway bars, moved gas tank to under the bed, headman hedders, new chrome bumpers,one wire alternator,Weber k550cub carburator...WORK IN PROGRESS, Freeland MI , Just bought a 72 Jimmy!!!!!!!!!!!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.