Cylinder sleeve and missing oil rings - The 1947 - Present Chevrolet & GMC Truck Message Board Network

hchad18 · 03-14-2009, 12:34 AM

I have a .060 over 327 that I am dead set on using. It was bored out, used for not long and then set to the side to get dirty. I recently pulled it apart and am just going to hone the cylinders and put it back together and noticed the number 1 cylinder had been sleeved. ANyone have any experience with how these hold up? Also on cylinders 1 and 2 they left one of the oil control rings off. I would have thought it to be forgot but they left the same one off both cylinders. Is there a reason for this?

03-14-2009, 12:34 AM	#1
hchad18 Registered User Join Date: Mar 2006 Location: AZ Posts: 372	Cylinder sleeve and missing oil rings I have a .060 over 327 that I am dead set on using. It was bored out, used for not long and then set to the side to get dirty. I recently pulled it apart and am just going to hone the cylinders and put it back together and noticed the number 1 cylinder had been sleeved. ANyone have any experience with how these hold up? Also on cylinders 1 and 2 they left one of the oil control rings off. I would have thought it to be forgot but they left the same one off both cylinders. Is there a reason for this? Last edited by hchad18; 03-14-2009 at 12:35 AM. Reason: typing after two beers



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.