Driver on a budget.

[TchncnDen]

Lookin good..

Looking very nice! Going to make a Very nice driver!

Thanks!!

Did you use rustolem on it? Looks like it was sprayed on.

Yep, it's rustoleum. I buy it in the quart cans and spray it through a gun, that doesn't break my Home Depot rule. The smell is no worse than the rattle cans, but it's cheaper, goes farther and lays down better on large areas. When I read your first reply to my use of rustoleum I chalked it up to one of three things. Either you had poor preparation, there's a compatability problem with por15, or the "real" rustoleum isn't available in your area. Well I looked at your thread and it definately wasn't poor preparation, nice job, and I can't really comment on the por15 compatability. What I did notice is that between the time I bought my first can on this project and the second can the selection at the store fell by about 75% and the can has a new look and no longer says oil based. That could be a bad sign. When I painted the bike gas was splashed often during fill ups and I never had a problem with that or on any other vehicles I've used it on. I hope that's still the case.

Damn I wished I had your body work skills, looking great!

I'm sure you could pull it off, it just takes time. There is plenty of advice and examples on this site anyone can follow. It just takes a little longer if you've never done it before. Oh, and thanks for the compliment.