383 FIRST START UP - Please be the judge...

[C10_Dreamin]

Guys, first of all I couldn't have gotten this far without this forum; great site to say the least!

Ok: I got to the point where I could start the break in of the cam(2000-2500 RPM for 30 minutes), got it broken in but I thought I heard a miss, can you hear anything? Everything seems to be working fine and as far as I know the Oil press, temp, voltage, and RPM are Ok.


Gen II GM Block
Delphi roller lifters
110 Degree Howard CAM flat tappet
10cc Forged Pistons
MSD HEI Dist. w/Rev Limiter built into Ign. Module.

Things I noticed:
15 PSI @ 500 RPM
45 PSI @ 2000 RPM
Rough Idle? It idled 100 RPM more when the stock ign. module was there.

Can you guys give me a 2nd opinion? Listen to the engine first, just audio then check out the gauges on video...

http://youtu.be/gacZK2mDbig

Thanks!!