Removing Saginaw from 350 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**KyleSeal** · 08-18-2015, 10:18 AM

So I did my first engine removal the other night. Now, onto disassembly.

Heres my problem: Removed all the bolts to the bellhousing, tried to pull the trans (with bellhousing) and it came out a little, maybe a half an inch, but no more.

My question(s): is this normal? If so, how can I remove it further? My dad said he thinks its hanging up on the input shaft. Is there anything I need to further disassemble?

Any pictures would help greatly.

Info: SB350, Saginaw 3 speed.

Thanks.

08-18-2015, 10:18 AM	#1
KyleSeal Senior Member Join Date: Mar 2014 Location: Toano, VA Posts: 847	Removing Saginaw from 350 So I did my first engine removal the other night. Now, onto disassembly. Heres my problem: Removed all the bolts to the bellhousing, tried to pull the trans (with bellhousing) and it came out a little, maybe a half an inch, but no more. My question(s): is this normal? If so, how can I remove it further? My dad said he thinks its hanging up on the input shaft. Is there anything I need to further disassemble? Any pictures would help greatly. Info: SB350, Saginaw 3 speed. Thanks. __________________ "Sometimes I do serve as a good bad example. Glad to be of service." My Build Thread (1967 C10, lowered, EFI, daily truck): http://67-72chevytrucks.com/vboard/s...d.php?t=830809



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.