|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-21-2015, 01:10 PM
|
#1 |
|
Old member
Join Date: Jan 2002
Location: Liberty, & Garden City S.C. , U.S.
Posts: 19,936
|
12 bolt 4:10 rear end!
I started on the rear pinion seal leak this morning. I jacked the drivers side up and put stands under it. Safety first. I marked everything so I can put everything back as it was. I counted 2.5 threads on the nut and I center punched all the parts to line back up. I took the drive shaft loose and put a 2x4 over the trailing arms to hold it up out of the way. I used my 18volt impact to get the pinion nut off which was pretty easy. I got everything took a part and cleaned up ready to reinstall. I'm waiting to pick up the new seal at O-Reilly's @2pm. Hopefully I'll be done this afternoon and post finshed pictures.
__________________
1971 LWB Custom, 6.0LS & 4L80E, Speedhut.com GPS speedometer & gauges with A/C. 20" Boss 338's Grey wheels 4 wheel disc brakes. My Driver Seeing the USA in a 71 Upstate SC GM Truck Club 2013,14 and 2016 Hot Rod Pour Tour http://upstategmtrucks.com/ Get out and drive the truck this summer and have some fun! It sucks not being able to hear! LWB trucks rule, if you don't think so measure your SWB! After talking to tech support at Air Lift I have found out that the kit I need is 60811. Per the measurements I gave them. Ride height of truck inside spring and inside diameter of springs. |
|
|
| Bookmarks |
|
|
Threaded Mode