Upper control arm bushings not fitting correctly?
I am in the process of replacing my upper control arm bushings. Just finished the bottoms with no problem. The upper bushings, seem to have close to a 3/16 gap on each side on the shaft, on the inside. The bushings seem to be close to the fittings, but the ones I took out didn't seem to have this gap. I measured the shaft and the bushings, same as what I am replacing. They squeal real bad when I lift the upper control arms too. Before I go any further figured I had better as if anyone has ran into this, is it ok? Or did I screw something up?
Thank you.
|