A-arm shaft?

[MolsonCanadian]

Originally Posted by jonmc56

Please have a look at post #17 AND #24 of my build thread. As mentioned in #24, the dimple needs to be facing up and 'slightly' toward the center of the truck, facing away from the ball joint. I wish I could remember what 'slightly' meant. I think it was at about the 1 o'clock position, but it has been a while.

http://67-72chevytrucks.com/vboard/s...d.php?t=560841

Hope this is helpful.
Jon

I know this is super old, however I'm putting my front end together. I get the fact that they should be towards the front and slightly towards centre, however, what does the notch index into? The Moog instructions say there should be a tang. I see nothing.