|
|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-01-2012, 11:44 AM
|
#1 |
|
Registered User
Join Date: May 2012
Location: Troy, Michigan
Posts: 1
|
1/2 ton driveshaft to 4 speed trans
I have a 1/2 ton '48ish torque tube style driveshaft/axle that I am putting a 4 speed manual trans of the same vintage in. The enclosed u-joint from the trans is larger(heavier spline) than the 1/2 ton u-joint. What is the best/easiest way to make the connection. I will send pix when available...any ideas?
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
