|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-10-2012, 03:25 PM
|
#1 |
|
Registered User
Join Date: Jan 2002
Location: Rhome, TX
Posts: 209
|
How to remove A/C knobs
I purchased an a/c control panel at a local swap meet and I am planning on installing a vintage a/c system in the near future and was cleaning up the panel. How do I remove the knobs that slide back & forth? Do I just pull on them with a pair of pliers, I could not see any set screws. I dont want to damage them.
Thanks Kevin
__________________
1968 C10 LWB 327 bored 40 over, RHS heads, KB pistons, Eagle rods, Edlebrock carb & intake 1968 C10 flatbed 307 w/ 4 spd manual (dads old ride) 1936 1/2 tn pickup, 400sb 350 turbo (partially restored) 1949 1/2 tn, needs complete restore (future project) 1969 Chevy impala 4 dr no post (wifes future car) 2010 GMC Serria 4x4 crew, leveling kit |
|
|
|
03-10-2012, 04:43 PM
|
#2 |
|
Registered User
Join Date: Jan 2002
Location: Rhome, TX
Posts: 209
|
Re: How to remove A/C knobs
I figured it out. I just took a pair of pliers and was able to pull them off without damaging them.
__________________
1968 C10 LWB 327 bored 40 over, RHS heads, KB pistons, Eagle rods, Edlebrock carb & intake 1968 C10 flatbed 307 w/ 4 spd manual (dads old ride) 1936 1/2 tn pickup, 400sb 350 turbo (partially restored) 1949 1/2 tn, needs complete restore (future project) 1969 Chevy impala 4 dr no post (wifes future car) 2010 GMC Serria 4x4 crew, leveling kit |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
