|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-27-2017, 12:12 PM
|
#1 |
|
Registered User
Join Date: Oct 2014
Location: Scottsdale, AZ
Posts: 465
|
Blazer Tailgate Moulding Holes
I'm getting ready to install the last two pieces of trim on our Blazer. So far I've been referencing a drawing that was posted on here of a 77 C10 for my holes and placements. However, with the Blazer gate being so different I've noticed that those #s don't make sense for this piece. My question is, can someone tell me how far from the left and right edge of the gate the push clip holes should be drilled?
|
|
|
| Bookmarks |
|
|
Threaded Mode