The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1960 - 1966 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


Reply
 
Thread Tools Display Modes
Old 11-06-2018, 12:15 AM   #1
1G1YY
Registered User
 
Join Date: Dec 2016
Location: South Australia
Posts: 13
Need measurement help 62 SWB..

I am trying to set up pinion angles using a T700 on a rolling chassis without any bodywork.

I will be fitting 4" drop coils in back.

I need to know the distance from ground to rear of lower part of chassis on a step with 235/75-15 wheels, as I note that there is a 3 degree variation of the rear end output shaft angle from from full compression to full extension.

If a member has a short stepside with 4" drop coils and could give me this measurement I would be grateful, so I can set that height on my chassis to get the rear end output shaft angle under normal ride height.

I am assuming the rear angle should be about 4 degrees but want to be sure before fabricating mounts for a Corvette C4 T700R4.

Thanks to those that can help with this..

Last edited by 1G1YY; 11-08-2018 at 07:19 AM.
1G1YY is offline   Reply With Quote
Old 11-08-2018, 07:20 AM   #2
1G1YY
Registered User
 
Join Date: Dec 2016
Location: South Australia
Posts: 13
Re: Need measurement help 62 SWB..

Ttt
1G1YY is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 03:05 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
Copyright 1997-2013 67-72chevytrucks.com