The 1947 - Present Chevrolet & GMC Truck Message Board Network

Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1960 - 1966 Chevrolet & GMC Pickups Message Board


Thread Tools Display Modes
Old 11-06-2018, 11:51 AM   #1
1960 GMC Burb
KIC's Avatar
Join Date: Jan 2008
Location: Arizona
Posts: 342
Removing slider windows

So I have a set of slider frames with glass in them out of a Burb. I need to remove the glass without tweaking or bending the frames so I can install the glass into my Burb.

What is the easy tip ? There always is an easy tip.....
1960 GMC Suburban
1/2 ton V-6
2nd generation original owner

60 Burb Build thread:

60 to 66 Burbs only Thread:
2003 Tahoe LT
KIC is offline   Reply With Quote
Old 11-06-2018, 12:51 PM   #2
Llay R. Rac
Senior Member
Llay R. Rac's Avatar
Join Date: Jul 2016
Location: Arizona
Posts: 233
Re: Removing slider windows

If you are talking about the whole unit, you remove the interior trim then a few bolts that go thru tabs that attach to the body. then remove the whole thing from the truck. then lay the frame flat with the non sliding section down and spread the frame to remove the sliding section. the '63 shop manual covers the side windows, also i found utube videos, i think steele rubber has some instructions on their site.
hope this helps. good luck, i redid all my side windows this summer, it was time consuming work, but well worth it.
1965 Suburban, 2 wd.,292, 4-speed.
proudly owned since 1969.
Llay R. Rac is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -4. The time now is 05:39 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2019, vBulletin Solutions Inc.
Copyright 1997-2013