|
05-23-2010, 02:52 AM
|
#1 |
|
Registered User
Join Date: Mar 2008
Location: Monroe, WA
Posts: 181
|
Drive line question
My 55 3200 came with a two piece drive line and a 4spd manual, now that I have swapped in a TH350 would it be better to have the original two piece shaft shortened or find a new one piece drive line?
-Joel |
|
|
|
05-23-2010, 04:19 AM
|
#2 |
|
Hollister Road Co.
Join Date: Apr 2005
Location: Houston
Posts: 6,134
|
Re: Drive line question
I had a 57 3200 that came with a one piece but it had a std 3 speed. The TH350 is longer so if you wanted you could run a once piece as long as its not over 50-52 inches. It may be cheaper to shorten you original one.
|
|
|
|
|
05-23-2010, 01:42 PM
|
#3 |
|
Registered User
Join Date: Jun 2006
Location: Idaho
Posts: 8,800
|
Re: Drive line question
I'd go with the one piece, less joints to wear out. Before the current set up I had a 4 speed 1-ton rear end with center joint too. They originally came on the longer wheel base big trucks.
__________________
1959 Chevy Short Fleetside w/ 74 4WD drive train (current project) OrrieG Build Thread 1964 Chevelle Malibu w/ 355-350TH (daily driver) Helpful AD and TF Manual Site Old Car Manual Project |
|
|
|
|
05-25-2010, 04:46 AM
|
#4 |
|
Cantankerous Geezer
Join Date: Aug 2002
Location: Bel Aire, KS
Posts: 6,264
|
Re: Drive line question
If your shaft isn't too long and the angles too sharp you could go with a one piece and get rid of the carrier bushing.
Take your measurements and talk to a local driveshaft shop. They can usually build a new shaft that is straighter and balanced better than the factory shaft.
__________________
Fred There is no such thing as too much cam...just not enough engine. 
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
