|
09-05-2017, 12:13 PM
|
#1 |
|
Senior Member
  
Join Date: Sep 2008
Location: Harrison, Arkansas
Posts: 9,788
|
Dip Stick Tube
I'm replacing the dipstick tube in my 72 with 350 engine. Does anybody have any tricks on how to press the tube in the block?
__________________
other Larry Build thread, Arkansas K10 https://67-72chevytrucks.com/vboard/...=755797&page=5 The ability to speak several languages is an asset, but the ability to keep your mouth shut in any language is priceless. |
|
|
|
09-05-2017, 12:21 PM
|
#2 |
|
Senior Member
Join Date: Jul 2015
Location: Fairfax, Missouri
Posts: 1,051
|
Re: Dip Stick Tube
An open end wrench around the flange and tap the wrench with a hammer will work .or a flat punch
|
|
|
|
|
09-05-2017, 12:35 PM
|
#3 |
|
Senior Member
Join Date: Sep 2008
Location: Harrison, Arkansas
Posts: 9,788
|
Re: Dip Stick Tube
I used a line wrench. It slid on and stayed by itself while I tapped it with a long screwdriver.
A nut would have worked well. Just slide it over the tube and tap with a punch or screwdriver.
__________________
other Larry Build thread, Arkansas K10 https://67-72chevytrucks.com/vboard/...=755797&page=5 The ability to speak several languages is an asset, but the ability to keep your mouth shut in any language is priceless. |
|
|
|
|
09-05-2017, 02:02 PM
|
#4 |
|
Senior Member
Join Date: Jul 2015
Location: Fairfax, Missouri
Posts: 1,051
|
Re: Dip Stick Tube
I also put some high temp RTV silicone about 1/2 in down from the flange to seal it up good.
|
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
