09-21-2017, 08:33 PM | #1 |
Registered User
Join Date: Jan 2008
Location: Raleigh, NC
Posts: 321
|
200-4R Pan Magnet
Does anyone know the size of the magnet that goes in the pan? Looking for the thickness and diameter. Thanks
|
09-21-2017, 08:40 PM | #2 |
Moderator
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,155
|
Re: 200-4R Pan Magnet
|
09-21-2017, 08:44 PM | #3 |
Registered User
Join Date: Feb 2015
Location: TX Hill Country
Posts: 150
|
Re: 200-4R Pan Magnet
Approximately .25" thick and 1.75" across.
|
09-21-2017, 08:51 PM | #4 |
Moderator
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,155
|
Re: 200-4R Pan Magnet
It is donut shaped with a hole in the center...
Hole is about 7/8" in diameter... |
09-21-2017, 08:55 PM | #5 |
Registered User
Join Date: Jan 2008
Location: Raleigh, NC
Posts: 321
|
Re: 200-4R Pan Magnet
Great. Thanks
Is this where they go? My pan was missing the magnet but I had just pulled apart a magnefine filter and it had a magnet that is 1/4" thick and just over 1.5" in diameter. |
09-21-2017, 09:17 PM | #6 |
Moderator
Join Date: Jun 2017
Location: Cherryville, NC
Posts: 2,155
|
Re: 200-4R Pan Magnet
It fits around a dimpled depression in the pan...that image looks correct...
|
Bookmarks |
|
|