|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-28-2017, 09:57 AM
|
#1 |
|
Registered User
Join Date: Sep 2012
Location: Pierce, WA
Posts: 115
|
Floor pan removal questions
Probably a stupid question but...What is the easiest way to separate the original pans from the supports? I can't easily see the spot welds. My supports look to be in good condition so I'd like to keep them in good shape.
Done a lot of research so far... but I can't find much info on the removing phase. I have just started to cut out the bad metal on the drivers side. I'll post some pics later |
|
|
|
04-28-2017, 12:34 PM
|
#2 |
|
Registered User
Join Date: Nov 2015
Location: Smethport, PA
Posts: 1,213
|
Re: Floor pan removal questions
Once you are able to bend the remaining floor pan it will become very clear where the spot welds are. You may have to cut the pan clear of the attachment areas so you can bend it.
__________________
85 K30 crew cab dually - Project http://67-72chevytrucks.com/vboard/s...d.php?t=694939 87 Wrangler Rock Crawler - Reason for the project http://www.wranglerforum.com/f330/da...ld-122601.html 04 1500 crew cab http://67-72chevytrucks.com/vboard/s...d.php?t=786514 |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
