|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-16-2002, 08:52 AM
|
#1 |
|
Senior Member
 Join Date: Mar 2001
Location: Cedar Park, TX
Posts: 686
|
Front Rotors to fit '71 truck?
Where can I get the best quality front
rotors to fit my truck. I measured the thickness of the old rotor and it seems to be approx to 1.250", is this correct? I am also going to replace the calipers due to excessive leakage. There seem to be so many selling different brands, with greatly differing prices, can anyone tell me anything good or bad? THanks. ------------------ 71 Chevy C-10 SWB Fleetside WAS:307w/3-on-the-tree NOW:350TBI/700R4/3.73 See it at www.prismnet.com/~grzanich
__________________
71 Chevy C-10 SWB Fleetside RamJet-350/4L60e & Compushift/3.73Posi See it at www.prismnet.com/~grzanich |
|
|
|
04-16-2002, 10:01 AM
|
#2 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Stock rotors are 1.250 like you measured. If they were mine I would just have the rotors trued up unless there are defects that are deeper than .015" The rotors can be turned
to 1.235" and if you have a good shop "true them up" they should work fine.(Truing them up is taking the bare minimum off to clean them up). Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
