? about bed - The 1947 - Present Chevrolet & GMC Truck Message Board Network

john j · 01-02-2005, 03:08 PM

HOW do you get the angle iron off the bed inside? The one at the bottom by the wood. I can't find where it is welded. Thanks johnj 58 long bed

MOTHERTRUCKERS · 01-07-2005, 10:34 PM

Clean the angle up a little with 80 grit sandpaper and you will see spotwelds about every 8 inches then use a drillbit or spot weld cutter.

john j · 01-08-2005, 11:10 PM

Thanks Mother. Do you carry them for a 97" bed? johnj

MOTHERTRUCKERS · 01-09-2005, 03:34 AM

We have them in steel ,stainless steel and polished stainless steel punched or unpunched.

01-02-2005, 03:08 PM	#1
john j Registered User Join Date: Mar 2003 Location: Newport NH Posts: 216	? about bed HOW do you get the angle iron off the bed inside? The one at the bottom by the wood. I can't find where it is welded. Thanks johnj 58 long bed __________________ you laugh at me cause i'm different ; i laugh at you cause you're the same

01-07-2005, 10:34 PM	#2
MOTHERTRUCKERS Registered User Join Date: Dec 1999 Location: BRADENTON FLA Posts: 3,269	Clean the angle up a little with 80 grit sandpaper and you will see spotwelds about every 8 inches then use a drillbit or spot weld cutter. __________________ Rest in Peace Ed. Thanks for all the good times.

01-08-2005, 11:10 PM	#3
john j Registered User Join Date: Mar 2003 Location: Newport NH Posts: 216	Thanks Mother. Do you carry them for a 97" bed? johnj __________________ you laugh at me cause i'm different ; i laugh at you cause you're the same

01-09-2005, 03:34 AM	#4
MOTHERTRUCKERS Registered User Join Date: Dec 1999 Location: BRADENTON FLA Posts: 3,269	We have them in steel ,stainless steel and polished stainless steel punched or unpunched. __________________ Rest in Peace Ed. Thanks for all the good times.



Register or Log In To remove these advertisements.