|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
05-15-2018, 01:06 PM
|
#1 |
|
Registered User
Join Date: Jun 2011
Location: Marion, NC
Posts: 851
|
62 c20 step notch placement question
Starting to mock up my welderseries step notch on my 62 and I was wondering if I need to just center it up over the axle or push it a little forward (I think?) to compensate for the arc of trailing arms. The notch is only 3 1/2 inches wide at the top so not a ton of room for error.
Thanks! |
|
|
|
05-16-2018, 05:47 PM
|
#2 |
|
Registered User
Join Date: Jul 2009
Location: San Jose Ca
Posts: 2,871
|
Re: 62 c20 step notch placement question
You definitely want to set it forward. You can calculate the forward movement or use a piece of string on the ground to replicate the movement.
__________________
David Used parts build: http://67-72chevytrucks.com/vboard/s...d.php?t=638991 My brother's Nova: http://www.67-72chevytrucks.com/vboa...d.php?t=727985 Rear suspension rework: http://www.67-72chevytrucks.com/vboa...d.php?t=750557 Instagram: myfabguy |
|
|
|
|
05-16-2018, 08:40 PM
|
#3 |
|
Registered User
Join Date: Oct 2014
Location: Mesa AZ (Near Phoenix)
Posts: 2,302
|
Re: 62 c20 step notch placement question
I move em forward 1/2 inch.
__________________
"Life is too short to drive a boring vehicle". Later, Wayne 
|
|
|
|
|
05-16-2018, 09:16 PM
|
#4 |
|
Registered User
Join Date: Jun 2011
Location: Marion, NC
Posts: 851
|
Re: 62 c20 step notch placement question
Thanks guys...I’ll move them 1/2” forward, then check with a string.
|
|
|
|
|
06-27-2018, 05:50 PM
|
#5 |
|
Registered User
Join Date: Apr 2015
Location: New Sharon iowa
Posts: 75
|
Re: 62 c20 step notch placement question
bumping a old post. I know when slamming a truck the wheel isn't centered in the wheel well. can I center the step notch up in the wheel and slid cross member back to make it look better?
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
