How do you remove door glass? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Sledge · 05-04-2002, 02:01 PM

Hey guys,

Anyone know how to remove the door glass from Blazer doors? My real problem is freeing the regulator arms from the channel on the bottom of the glass. I unbolted the regulator to try and slide the rollers along to the holes in the channel/track -- but the post on which the handle attaches gets hung up on the hole in the inner door skin.

Anyone have any advice?

**Desert Rat** · 05-04-2002, 02:10 PM

did you pull the vent wondow,or loosen up the regulator.

*Fast68Chevy* · 05-04-2002, 02:15 PM

1. remove rear track
2. slide glass back as far as will go
3. remove vent wing assembly
4. make sure glass is rolled all way down
5. slide glass fore and aft till rollers fall out of glass track, use flashlight, youll see notches on face of track towards you towards inside of cab,
6.pull glass out of door
7. youre done, go party

Sledge · 05-04-2002, 10:58 PM

Thanks Fast, sucker popped right out once I knew the right sequence!

05-04-2002, 02:01 PM	#1
Sledge Registered User Join Date: Mar 2001 Location: Oregon Posts: 21	How do you remove door glass? Hey guys, Anyone know how to remove the door glass from Blazer doors? My real problem is freeing the regulator arms from the channel on the bottom of the glass. I unbolted the regulator to try and slide the rollers along to the holes in the channel/track -- but the post on which the handle attaches gets hung up on the hole in the inner door skin. Anyone have any advice?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

05-04-2002, 02:10 PM	#2
Desert Rat Senior Member Join Date: Dec 1999 Location: Darrington, Washington Posts: 3,963	did you pull the vent wondow,or loosen up the regulator.

05-04-2002, 02:15 PM	#3
Fast68Chevy Account Suspended Join Date: May 2000 Location: IL Posts: 0	1. remove rear track 2. slide glass back as far as will go 3. remove vent wing assembly 4. make sure glass is rolled all way down 5. slide glass fore and aft till rollers fall out of glass track, use flashlight, youll see notches on face of track towards you towards inside of cab, 6.pull glass out of door 7. youre done, go party

05-04-2002, 10:58 PM	#4
Sledge Registered User Join Date: Mar 2001 Location: Oregon Posts: 21	Thanks Fast, sucker popped right out once I knew the right sequence!



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.