|
LS build, parts questions
I know that this is not the LS side, but my questions are more to the side of parts manufacture. I plan to have a 5.3 bored 3mm & run a Mahle set of LS1 pistons (4032 alloy spec), for street use. My thoughts are, that if the crank passes magnaflux & cleans up .010/.010, It should be good for a 400 hp engine? The rods I question, as the mill is well seasoned (285,000 miles)! I dont want any junk from China in my Chevy  Any advise on rods & maybe a forged crankshaft, would be helpfull. Longhorn 
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
|
01-11-2017, 06:15 PM
Threaded Mode