|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-29-2009, 03:19 PM
|
#1 |
|
Registered User
Join Date: May 2007
Location: USA
Posts: 16
|
4WD Selector Lever Light Replacement?
Hello folks,
I have recently discovered the light/bulb that illuminates my transfer case selector, or 4wd lever inside the cab on the floor (i.e. 2 wheel hi, 4 wheel low etc.) has ceased burning. Any tips on replacing said bulb? I remember it functioning but there is no bulb visible inside the little plastic window. The truck is an '87 K5 350. Thank you for any help or information! |
|
|
|
01-29-2009, 10:56 PM
|
#2 |
|
Slots go on anything!
Join Date: May 2003
Location: Richardson, TX
Posts: 5,957
|
Re: 4WD Selector Lever Light Replacement?
there are 2 screws in the front and 2 in the rear of the black console. Remove them, and lift up. You will see the wiring and the bulb.
|
|
|
|
|
01-30-2009, 07:31 PM
|
#3 |
|
Registered User
Join Date: May 2007
Location: USA
Posts: 16
|
Re: 4WD Selector Lever Light Replacement?
Thank you Jonboy. Took care of the bulb this morning, bulb no. 194, pack of two cost $2.59 at NAPA. Thanks again.
|
|
|
|
|
| Bookmarks |
| Tags |
| blazer, light, selector, transfer |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
