|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-26-2009, 09:59 PM
|
#1 |
|
Registered User
Join Date: Mar 2009
Location: Eatonville, WA
Posts: 2
|
2wd to 4wd 1 ton conversion
I am new to the forum and with a little looking I have found several posted pics of 4X4 1 ton duallys. Since the 4X4 1 ton dually did not make its appearance until somewhere around 1976 or 1977, I am curious how these conversions are done. Is it easier to do a complete frame swap or is it easier to do a front drive axle install? Any help is greatly appreciated.
HMMike |
|
|
|
03-26-2009, 11:47 PM
|
#2 |
|
Registered User
 
Join Date: Feb 2001
Location: East Central, MO
Posts: 11,339
|
Re: 2wd to 4wd 1 ton conversion
Welcome to the site. Moving this over to 4x4.
|
|
|
|
|
03-28-2009, 06:42 PM
|
#3 |
|
Post Whore
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,683
|
Re: 2wd to 4wd 1 ton conversion
My buddy has a 1970 1 ton that he converted to 4wd. He had a donor 3/4 ton 4wd and swapped parts over so the front axle was a Dana 44 not a Dana 60. He said the conversion wasn't too bad since he had both vehicles there to confirm where he needed to put stuff. He has a Dana 60 front axle and a Dana 70 rear axle he's gonna swap in when time allows so it will be a true 1 ton 4wd when that is done.
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
|
|
|
|
03-29-2009, 10:07 PM
|
#4 |
|
Registered User
Join Date: Mar 2009
Location: Eatonville, WA
Posts: 2
|
Re: 2wd to 4wd 1 ton conversion
Thanks Yukon Jack. Which years of Dana 60 and Dana 70 are used for this conversion.
Thanks Again HMMike |
|
|
|
|
| Bookmarks |
|
|
Linear Mode
