|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
04-09-2002, 02:25 PM
|
#1 |
|
king $h!t
Join Date: Jan 2002
Location: spring valley/ohio/usa
Posts: 416
|
has any one used axle shims
i am geting ready to put my lift on win this thought came past my mind my axle isnt going to set at the right angel any more i heard of axle shims but most people use the on lowerd car and such
__________________
j dawg the 86 allmost done 357/700r4/lifted 9/dana44 front ten bolt rear/3.73 gears/35s |
|
|
|
04-10-2002, 07:22 AM
|
#2 |
|
Registered User
Join Date: Aug 2001
Location: rock island,il,usa
Posts: 5,382
|
I have used them ,on lowered ,or modified suspensions. Raising can do the same thing. Shims should be available at your local spring shop,& they can supply you with a spring center bolt that has a longer locator pin if need. Good luck.....69 longhorn.
__________________
http://community.webshots.com/user/hotrodhorn |
|
|
|
|
04-10-2002, 04:38 PM
|
#3 |
|
Post Whore
 
Join Date: Feb 2000
Location: Rose Hill, KS, USA
Posts: 12,683
|
May not be much of an issue, depends on how high you are going. Usually you don't have a problem with a 4" lift, probably an issue with a 6" or higher.
------------------ 1969 C20 4x4 with roughly 6" lift and 35's residing near Rose Hill, Kansas Yukon Jack's Web Pages
__________________
1970 Blazer with a 400 sbc and 4" lift 1980 Pontiac Trans Am, 455 Oldsmobile 2012 Kawasaki Concours 14 |
|
|
|
|
04-10-2002, 08:29 PM
|
#4 |
|
king $h!t
Join Date: Jan 2002
Location: spring valley/ohio/usa
Posts: 416
|
well the lift is six inch and i have a three inch body lift
__________________
j dawg the 86 allmost done 357/700r4/lifted 9/dana44 front ten bolt rear/3.73 gears/35s |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
