Fuel & Brake line chassis tabs/clips

[hotrod1]

Building a new chassis. Need ideas for fuel (1/2") and brake line tabs or clips. Want to get them planned before welding in the cross-members. Seen anything cool?

[Speedbumpauto]

Go to Summit and put "line clamp" in the search engine. Gives lots of options. I made my own using 1/2" aluminum bar stock and a drill press. Look like Billet Specialties but instead of tapping the aluminum, drilled through and used 10-24 nutserts in the frame so the clamp attached to the frame. A little time consuming but using different size drill bits, I could run any size and number of lines I wanted. Using the belt sander for contour, they didn't even look too bad.

[dwcsr]

https://www.aa-mfg.com/ has pretty much any tab, gusset or bracket you may need.

[hotrod1]

Thanks guys.

Found these on summit (speedbump credit). They Look interesting. http://www.notchead.com/line-clamps.html

[Kim57]

You can see what I used in this pic.A little time consuming but turned out O.K.
I think mine are Kugel.
A link to similar ones at speedway.
http://www.speedwaymotors.com/Stainl...FUhufgod7MgMBw
Kim

[BIGglaSS]

"P" clamps + rivnuts