03-07-2017, 05:35 PM | #1 |
Registered User
Join Date: Jun 2016
Location: Manassas, VA
Posts: 112
|
HEI wiring questions
So I recently bought an '86 C10 that had a late 70's 350 dropped in it. I just replaced the carburetor with a brand new summit brand carb along with replacing the distributor with an original that was pulled from a running vehicle. I replaced the entire distributor because the original had red dust all inside of it and I got a good deal on the "new" one. I also have a new cap, rotor and coil and the issue I am having is that the truck will intermittently not start due to no spark, I have it nailed down to the wiring in the distributor area. It is either the wires running to the distributor or the wires inside because if I move the wires around or tap the top of the cap it fires right up.
I just bought a new PICO wiring connector to replace the older one running from the ignition but all the ones I see just have one wire for the ignition, however mine has two... So does anyone know what the second wire might be and is it needed? I don't have a tach in the truck. Here is what I bought: Here is my current setup:
__________________
1986 C10 LWB 350 1970 C10 LWB 350 - Sold |
Bookmarks |
|
|