The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board > The 1973 - 1991 Blazers, Jimmys, and Suburbans Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-27-2017, 12:12 PM   #1
phillipm
Registered User
 
Join Date: Oct 2014
Location: Scottsdale, AZ
Posts: 435
Blazer Tailgate Moulding Holes

I'm getting ready to install the last two pieces of trim on our Blazer. So far I've been referencing a drawing that was posted on here of a 77 C10 for my holes and placements. However, with the Blazer gate being so different I've noticed that those #s don't make sense for this piece. My question is, can someone tell me how far from the left and right edge of the gate the push clip holes should be drilled?

phillipm is offline   Reply With Quote
 

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:30 AM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2018, vBulletin Solutions Inc.
Copyright 1997-2013 67-72chevytrucks.com