1969 C10 4x4 Project - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Sven · 08-13-2011, 01:57 PM

I must be nuts, it's hot as hell outside and a little humid but I couldn't resist. I cleaned out the truck bed, put the truck on axle stands and pulled off the wheels. I pulled off three of the brake drums (one is sticky) before my heart rate was in the red zone and I was sweating my a$$ off. I'll tackle the other drum when I've had a nap ...

I want to replace the wheel studs while I'm in there as a few are rusty and one snapped recently. Also, the ones in there are a little short. I'll run down to O'Reilly and rent a tool to remove/install them.

-Steve

08-13-2011, 01:57 PM	#9
Sven Registered User Join Date: Dec 2009 Location: Laveen, AZ Posts: 69	Re: 1969 C10 4x4 Project I must be nuts, it's hot as hell outside and a little humid but I couldn't resist. I cleaned out the truck bed, put the truck on axle stands and pulled off the wheels. I pulled off three of the brake drums (one is sticky) before my heart rate was in the red zone and I was sweating my a$$ off. I'll tackle the other drum when I've had a nap ... I want to replace the wheel studs while I'm in there as a few are rusty and one snapped recently. Also, the ones in there are a little short. I'll run down to O'Reilly and rent a tool to remove/install them. -Steve __________________ 1969 Chevrolet 4x4 C10 Pickup



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.