divorced np205 transfer case, pinion and u joint angles

[raylube]

Originally Posted by 72cs20

Ray,

How are those front springs mounted? The stock front brackets and rear shackles? Modifications?

I'm thinking of trying out those front springs, but in a 4 inch lift.

Thanks

Mine are tuff country springs 72 Chevy 6 inch lift springs ez ride mounted on front stock brackets and rear shackles. Drilled front bracket holes to 3/4 inch and ground out a little from the inside, used greaseable poly bushings from ORD and cut them flush to spring width and then ran steel center bushing from the ORD thru stock brackets into the poly bushing and ground them flush and bolted them with a 5/8 greaseable bolt. Rear of front springs i using 79 k20 shackles drilled to fit stock threaded bushing.

[raylube]

Originally Posted by 72cs20

Ray,

How are those front springs mounted? The stock front brackets and rear shackles? Modifications?

I'm thinking of trying out those front springs, but in a 4 inch lift.

Thanks

only photos i have.

[72cs20]

Thank you! This is basically how I envisioned going about it.