|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-25-2017, 05:46 PM
|
#1 |
|
Registered User
Join Date: Jun 2013
Location: Tucson, AZ
Posts: 44
|
56 Firewall how much lip
Hello all, I'm in the process of smoothing my firewall. How far back on each side do I need to remove on the firewall lip? I know some is covered by inner fender.
Thanks! |
|
|
|
08-25-2017, 07:34 PM
|
#2 |
|
Registered User
Join Date: Jan 2012
Location: Motown
Posts: 7,662
|
Re: 56 Firewall how much lip
i took the flange down to just below the upper hinge bolt
the seam shows behind my 58 (different) hood hinge but not in the overall picture had i gone lower there was a lot more work below the seam and wrinkles you see in the firewall pic
__________________
cool, an ogre smiley  Ogre's 58 Truk buildhow to put your truck year and build thread into your signature shop air compressor timer |
|
|
|
|
08-25-2017, 07:53 PM
|
#3 |
|
Registered User
Join Date: Jun 2013
Location: Tucson, AZ
Posts: 44
|
Re: 56 Firewall how much lip
Thanks so much!! That's exactly what I was looking for. Even better that's about where I stopped cutting! Yay! I'm removing the entire firewall and building one out of sheet metal. Couldn't remember what the inner fender covered.
Thanks again! |
|
|
|
|
08-26-2017, 12:03 PM
|
#4 |
|
Registered User
Join Date: Jan 2012
Location: Motown
Posts: 7,662
|
Re: 56 Firewall how much lip
your 56 is a little different than truk
close enough
__________________
cool, an ogre smiley Ogre's 58 Truk buildhow to put your truck year and build thread into your signature shop air compressor timer |
|
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
