|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
01-18-2019, 03:04 AM
|
#1 |
|
Registered User
Join Date: Sep 2018
Location: California
Posts: 151
|
TH400 Kickdown Wire Question
I am in the process of resealing my TH400. When I pulled the kickdown solenoid wires off of the solenoid to remove it and change the o-ring I noticed that the insulation on the two wires was cracked.
Is this going to cause problems or can I just leave it? (correct me if I'm wrong on the terminology of this "kickdown solenoid") |
|
|
|
01-18-2019, 07:51 AM
|
#2 |
|
Senior Member
 
Join Date: Aug 2004
Location: Centennial, CO
Posts: 2,883
|
Re: TH400 Kickdown Wire Question
ATF isn’t conductive, so just keep the wires away from the metal. There’s probably a replacement available, but that’s what I did when I bebuilt the 400 in the Cadillac.
__________________
ClusterTruck: 68 C10 Bought in 89, wrecked in 03. Slow low $ rebuild started '17. 6.0 & TKO http://67-72chevytrucks.com/vboard/s...d.php?t=788602 93 K1500 Short Step, 350, NV4500, EBL flash ECU. Vortec heads & roller cam someday... 05 Jeep Wrangler Unlimited. 3” lift & 6-speed 02 E320 the insurance total “free car” 13 Tahoe LTZ |
|
|
|
|
01-18-2019, 01:08 PM
|
#3 |
|
Registered User
Join Date: Sep 2018
Location: California
Posts: 151
|
Re: TH400 Kickdown Wire Question
Sounds good, thanks.
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
