|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
 |
|
|
Thread Tools | Display Modes |
06-15-2020, 09:19 PM
|
#1 |
|
Senior Member
 Join Date: Mar 2016
Location: Athens, AL
Posts: 353
|
Odd request, metal bed channel measurements
My truck is at the body shop. Can someone tell me the depth of the metal channels molded into the bed (straight edge across top ones, and measure to lowest point of the valley)? And what is the distance from center to center of the high ridges? Thanks.
Last edited by General23cmp; 06-15-2020 at 09:55 PM. |
|
|
|
06-16-2020, 11:24 AM
|
#2 |
|
Senior Member
Join Date: Mar 2012
Location: Chesapeake, Va
Posts: 1,275
|
Re: Odd request, metal bed channel measurements
why can't the body shop take those measurements??
__________________
Mike 72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider. 421 SBC / TH350 3000RPM Stall Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks 
|
|
|
|
|
06-16-2020, 11:43 AM
|
#3 | |
|
Senior Member
Join Date: Mar 2016
Location: Athens, AL
Posts: 353
|
Re: Odd request, metal bed channel measurements
Quote:
|
|
|
|
|
|
| Bookmarks |
|
|
Linear Mode
