|
07-13-2019, 01:13 PM
|
#1 |
|
Registered User
Join Date: Sep 2018
Location: Dayton Oh
Posts: 125
|
Ball joint
Does my 67 have a ring to remove before I press the ball joint out
|
|
|
|
07-13-2019, 01:39 PM
|
#2 |
|
Senior Member
 
Join Date: Dec 2013
Location: Gods country East,Tn
Posts: 8,545
|
Re: Ball joint
No .
__________________
 1967 Factory short bed - Old school '71 - 350 / 4bolt / 487 heads / Edelbrock C3BX Muncie M-22 4 speed / Hurst Comp plus Factory 12 bolt posi 3.73 / 255-70-15 Smoothed firewall / Factory cowl induction Power disc brakes / power steering / 3.5-5" drop |
|
|
|
|
07-13-2019, 06:18 PM
|
#3 |
|
Registered User
Join Date: Sep 2018
Location: Dayton Oh
Posts: 125
|
Re: Ball joint
Thanks Grumpy, I didn’t think so!! I may have done this in the wrong order but I took the lower control arms off before trying to remove the ball joints and as of right now I can’t get them out I’m using a ball joint press with a 2 1/2 foot breaker bar and can’t get them to budge. I figure I’ll soak them overnight and PB blaster and give it a shot in the morning
I’m pretty sure I’m using this press correctly,The shaft of the ball joint hanging through the bottom is loose and not contacting the press at any point. I will post a photo, any advice would be appreciated |
|
|
|
 |
| Bookmarks |
|
|
Linear Mode
